Last Thursday, however, I was out because I took a trip to Orlando to pick up the AR lower receiver that I bought from Spike's Tactical for a song ($65.00, including tax).
Now begins the (potentially) fun part of saving up for, buying, and then installing the various pieces of kit needed to turn this firearm into an actual, usable rifle. Fortunately for me, WizardPC over at Guns, Cars & Tech is going through the same process, so I'm going to pillage his linkdump for useful instructions and shopping lists.
Note 1: I cannot tell you how disappointed I was that a post titled My Little AR Build had no references to ponies anywhere.
Note 2: Yes, building an AR is a complicated process full of choices and lots of shopping. As McThag says, "You can't spell Barbie without an AR." Given how the AR platform allows a shooter to swap calibers and accessories with the switch of an upper, there's a lot of truth to this comparison.What may amuse some of you non-gunnies out there is that I didn't mis-speak earlier: according to the BATF, this piece is the actual firearm; everything else, including the barrel, is an accessory that doesn't need a background check. Yes, if I took this chunk of
I shall now pause to allow you to laugh.
Here's a close-up of the Florida design on the receiver. I haven't yet decided upon a name for this one yet -- I imagine that will evolve as I assemble the rifle -- but it should be something which suggests a local flavor.
 |
| The dot indicates the location of the manufacturer: Apopka, Florida. |
The only thing I've done to it so far is to remove some the of roughness of the coating. When I first got the receiver, it was a VERY deep black and had a texture that gave me the same shivers as when I hear nails on a chalkboard.* I knew that wouldn't be acceptable for anything I would need to touch regularly, so I took a bronze brush and gave the surfaces a good going-over. This smoothed over a lot of the pores and gave the surface a thin coating of bronze, when I then scrubbed off (mostly) with a stiff nylon brush. What little was left behind gave the piece a slightly weathered look. It's not very visible in the pictures, but the difference is between "everything is exactly the same shade of deep black" and "due to variations in surface topography, some places are lighter than others and now it has a sense of relief and shading."
Also, I can hold it without getting the heebie-jeebies, which is an important feature in a rifle.
*Actually, it felt exactly like uncoated ceramic. Touching that and hearing nails on a chalkboard give me the exact same shivers.
PDF
